CompTIA JK0-801 A+ Networking & PC Hardware Practice Exam Set 3

After setting up a new computer, a user states that the mouse and keyboard will not work. Which of the following is the MOST likely reason


Options are :

  • The USB connectors are switched
  • The network cable is disconnected
  • The PS/2 connectors are switched (Correct)
  • The hard drive is unplugged

Answer : The PS/2 connectors are switched

220-902 CompTIA A+ Certification Practice Exam Set 6

Which of the following is the form factor of a standard Parallel connector


Options are :

  • DIN-6
  • DB-9
  • DB-15
  • DB-25 (Correct)

Answer : DB-25

Which of the following characteristics is generally found on a docking station that port replicators do not offer


Options are :

  • Docks have independent hardware that replicators lack. (Correct)
  • Replicators usually have more USB ports than docks.
  • Docks generally do not need separate power to function.
  • Replicators have additional NIC that docks lack.

Answer : Docks have independent hardware that replicators lack.

After a technician installs a video card, which of the following should the technician configure NEXT


Options are :

  • Refresh rate
  • Colors
  • Resolution (Correct)
  • Dots per inch

Answer : Resolution

CompTIA Network+ 6 Certification Practice Exams - 2019 Set 10

A technician is asked to upgrade RAM in a laptop from 4GB to 8GB. Which of the following should the technician do FIRST


Options are :

  • Flash the BIOS
  • Enable TPM
  • Download the newest motherboard drivers
  • Review the vendor laptop documentation (Correct)

Answer : Review the vendor laptop documentation

When a power supply does not meet minimum requirements for a motherboard, which of the following can happen


Options are :

  • Monitor will not power on
  • Computer will not POST (Correct)
  • Processor will not run at proper speed
  • Computer will overheat

Answer : Computer will not POST

A threaded coaxial connector used to connect to a TV tuner is MOST often referred to as which of the following


Options are :

  • IEEE 1394 connector
  • RJ-45 connector
  • RJ-11 connector
  • F-connector (Correct)

Answer : F-connector

CompTIA Cyber Security Analyst (CySA+) Practice Exams 2019 Set 12

A technician is dispatched to install additional RAM in a computer. The technician unplugs the system from the power source, and removes the cover of the PC. Which of the following should the technician do NEXT


Options are :

  • Use an anti-static bag to hold the RAM while installing.
  • Clean out the PC with compressed air.
  • Put on an ESD strap (Correct)
  • Update the BIOS for compatibility

Answer : Put on an ESD strap

To configure two drives for MAXIMUM performance, which of the following RAID types should be used


Options are :

  • RAID 5
  • RAID 10
  • RAID 1
  • RAID 0 (Correct)

Answer : RAID 0

Which of the following should a technician do NEXT after reporting an incident


Options are :

  • Go back to work
  • Delete the content
  • Document the incident (Correct)
  • Confiscate the PC

Answer : Document the incident

CompTIA PD1-001 PDI+ Beta Certification Practice Exam Set 7

A technician is tasked with selecting components to build a computer that will be used for computer-aided drafting and computer aided modeling. Which of the following components are the BEST choicesX (Select TWO).


Options are :

  • MIDI sound card
  • Triple channel memory (Correct)
  • Socket 1156 motherboard
  • Socket 1366 CPU (Correct)
  • Onboard graphics

Answer : Triple channel memory Socket 1366 CPU

When installing multiple SCSI drives in a system, which of the following is correct


Options are :

  • All drives must have the same SCSI ID.
  • Each drive must have a different SCSI ID. (Correct)
  • Drives in the same RAID array must have the same SCSI ID.
  • Drives will be automatically assigned an ID by the controller.

Answer : Each drive must have a different SCSI ID.

A composite cable connects to which of the following connectors


Options are :

  • HDMI
  • RCA (Correct)
  • S-video
  • DVI

Answer : RCA

JK0-015 CompTIA E2C Security+ 2008 Edition Practice Exam Set 10

A technician would like to connect to a computer using remote desktop. Which of the following ports does remote desktop use by default


Options are :

  • 8080
  • 22
  • 443
  • 3389 (Correct)

Answer : 3389

Which of the following RAID types uses a drive mirroring algorithmX (Select TWO).


Options are :

  • RAID 1 (Correct)
  • RAID 0
  • RAID 6
  • RAID 5
  • RAID 10 (Correct)

Answer : RAID 1 RAID 10

Which of the following characteristics BEST differentiates a Home Theatre PC from a CAD PC


Options are :

  • Small form factor (Correct)
  • Gigabit network connection
  • Ability to edit large files
  • Ability to play optical media

Answer : Small form factor

HT0-201 CEA- CompTIA DHTI+ Certification Practice Exam Set 1

Video editing workstations require the fastest hard drive access times with large storage capacity. Which of the following hard disk setups would be MOST ideal for the described computer


Options are :

  • Two 500 GB SATA2 hard drives used in a JBOD array
  • Two 500 GB SATA2 hard drives in a software RAID 0
  • Two 500 GB SATA2 hard drives in a hardware RAID 1
  • Two 500 GB SATA2 hard drives in a hardware RAID 0 (Correct)

Answer : Two 500 GB SATA2 hard drives in a hardware RAID 0

A technician wants to install a secondary IDE drive which will be configured for additional user storage on the same IDE channel of the drive with the operating system. Which of the following jumper configurations should the technician use for the additional drive, if the drive with the operating system is set to MA


Options are :

  • Place a jumper on the MA jumper block of the secondary drive.
  • Place a jumper on the SL jumper block of the secondary drive. (Correct)
  • Place a jumper on both the MA and CS jumper block of the secondary drive.
  • Place a jumper on both the SL and CS jumper block of the secondary drive.

Answer : Place a jumper on the SL jumper block of the secondary drive.

Joe, a technician, installs a new Blu-Ray player via an external cable. The PC has previously had a USB 3.0 expansion card installed into its PCI Express slot. When Joe powers on the Blu-Ray player, he notices the "USB 2.0 Device" pop up in the Windows System Tray. Which of the following are probable causesX (Select TWO).


Options are :

  • A virus is attacking the USB 3.0 driver, forcing it to operate in USB 2.0 mode only.
  • The Blu-Ray player was mistakenly plugged into the FireWire port.
  • The Bluetooth connection from a nearby mobile device is interfering with the BluRay player.
  • The technician that installed the USB 3.0 expansion card forgot to install the USB 3.0 driver. (Correct)
  • The Blu-Ray player is plugged into the wrong port on the back of the PC. (Correct)
  • The Blu-Ray player had a DVD loaded into it and this caused the computer to malfunction.

Answer : The technician that installed the USB 3.0 expansion card forgot to install the USB 3.0 driver. The Blu-Ray player is plugged into the wrong port on the back of the PC.

Practice : CompTIA Network+ (N10-007)

Ann, a user, has recently installed a new Blu-Ray ROM in her desktop computer. The computer recognizes the device as a DVD-ROM. Which of the following actions would enable the system to recognize the device as a Blu-Ray device


Options are :

  • The operating system must be upgraded to Windows Ultimate.
  • Install the manufacturer's drivers for the OS. (Correct)
  • Flash the system's motherboard CMOS.
  • Upgrade to the latest Windows Media Player.

Answer : Install the manufacturer's drivers for the OS.

RG-59 is a designation for which of the following cable types


Options are :

  • Plenum
  • Coaxial (Correct)
  • Fiber optic
  • Twisted pair

Answer : Coaxial

A customer has asked for the ability to operate dual digital monitors. Which of the following is the BEST solution for accomplishing this


Options are :

  • Add an adaptor to the onboard VGA port.
  • Split the onboard video port.
  • Install a video card with multiple DVI ports. (Correct)
  • Update the video drivers to allow for multiple monitors.

Answer : Install a video card with multiple DVI ports.

Mock : CompTIA A+ Certification 220-902

Which of the following uses a single connector to deliver both video and audio


Options are :

  • VGA
  • HDMI (Correct)
  • Serial
  • DVI

Answer : HDMI

On an ATX motherboard, the 4-pin auxiliary power connector provides which of the following


Options are :

  • Additional power to PCIx peripheral cards
  • Additional power to onboard devices
  • Additional power to the CPU voltage regulator (Correct)
  • Additional power to the South Bridge

Answer : Additional power to the CPU voltage regulator

Which of the following types of connectors would be found to connect printers and scanners to a device that did not have any network connections


Options are :

  • BNC
  • RJ-11
  • Parallel (Correct)
  • RJ-45

Answer : Parallel

220-801 CompTIA A+ Certification Practice Exam Set 11

Joe, a user, has installed a new monitor on an existing system. Joe calls a support technician and reports that everything on the new display is fuzzy. Which of the following describes what needs to be changed to correct this issue


Options are :

  • The old graphics card does not support the new monitor
  • The display resolution needs to match the native resolution. (Correct)
  • The new monitor requires updated drivers to be installed.
  • The new monitor cable needs to have aluminum cores installed.

Answer : The display resolution needs to match the native resolution.

Which of the following requires a MINIMUM of four hard drives


Options are :

  • RAID 1
  • RAID 5
  • RAID 0
  • RAID 10 (Correct)

Answer : RAID 10

Which of the following panel types would allow for the THINNEST possible display monitor


Options are :

  • DLP
  • LED (Correct)
  • Plasma
  • CRT

Answer : LED

CompTIA JK0-015 E2C Security+ Certification Practice Test Set 9

Which of the following adapter types uses a 7-pin cable to transmit video signals


Options are :

  • S-Video (Correct)
  • DVI
  • RGB
  • HDMI

Answer : S-Video

Which of the following are factors when designing a home theater PC


Options are :

  • Audio frequency
  • Video refresh rate
  • Wireless NIC
  • Video output (Correct)

Answer : Video output

Comment / Suggestion Section
Point our Mistakes and Post Your Suggestions