210-065 Implementing Cisco Video Network Devices Exam Set 4

You boot a Cisco TelePresence System TX1300. A red X appears on the screen during step 4 in the boot process. Which of the following should you do?


Options are :

  • Contact Cisco Technical Support
  • Configure a static IP address.
  • Check the network port and the Ethernet cable.
  • Check the status of the DHCP server.
  • Reboot the system.

Answer : Check the network port and the Ethernet cable.

Cisco Data Center Architecture Set 4

You are attempting to recover the password on a CTS endpoint. Which of the following scenarios will cause the password recovery session to abort? (Choose three.)


Options are :

  • The CTS is on a call.
  • You take longer than 60 seconds to respond to a prompt.
  • You attempt to connect to the codec by using SSH.
  • Another administrator is attempting to reset the password.

Answer : The CTS is on a call. You take longer than 60 seconds to respond to a prompt. Another administrator is attempting to reset the password.

Which of the following is a view mode that displays all of the participants equally?


Options are :

  • Room Switching
  • Voice Switched
  • Speaker Switching
  • Continuous Presence

Answer : Continuous Presence

A SIP endpoint attempts to register with a Cisco VCS by using an alias that has previously been registered from another IP address. Which of the following will occur if the Cisco VCS is configured with the default settings?


Options are :

  • The VCS will replace the old registration with the new registration.
  • The VCS will deny the new registration and maintain the old registration.
  • The VCS will allow the new registration while maintaining the old registration.
  • The VCS will deny the new registration and remove the old registration.

Answer : The VCS will allow the new registration while maintaining the old registration.

200-125 Cisco Certified Network Associate Practice Exam Set 12

Which of the following are found in the audit log on a Cisco TelePresence MCU?


Options are :

  • H.323 messages and SIP messages
  • video sharing and collaboration
  • configuration changes
  • call detail records

Answer : configuration changes

Which of the following is not supported by Cisco TMSPE?


Options are :

  • scheduled and on-demand directory synchronization
  • automated emailing of provisioning information
  • import of Active Directory and LDAP user accounts
  • provisioning of up to 1,000,000 users

Answer : provisioning of up to 1,000,000 users

Which tab on the web interface of the Cisco Codec C60 contains information regarding the sign-in banner?


Options are :

  • Maintenance
  • Call Control
  • Configuration
  • Diagnostics

Answer : Configuration

Cisco 210-060 Implement Collaboration Device Practice Exam Set 2

Which of the following is the NRC rating that indicates a complete absorption of sound?


Options are :

  • 99
  • 0
  • 100
  • 1

Answer : 1

Which of the following commands should you issue to configure a CTMS so that someone must speak between 2.5 and 3.5 seconds before becoming the active speaker in a VIP mode conference?


Options are :

  • set damping vip on
  • set damping vip medium
  • set damping vip fast
  • set damping vip slow

Answer : set damping vip slow

You connect Ethernet Port A on a Cisco TelePresence MCU 5300 Series device to the network. The device is currently using the default settings. A DHCP server exists on the network. Which of the following will be displayed when you issue the status command?


Options are :

  • A dynamic IPv4 address and a dynamic IPv6 address will be displayed.
  • The default static IPv4 address will be displayed.
  • A dynamic IPv4 address will be displayed.
  • The default static IPv6 address will be displayed.

Answer : A dynamic IPv4 address will be displayed.

200-125 CCNA Cisco Certified Network Associate Test Set 2

Which of the following features is used to configure Multiway on Cisco VCS?


Options are :

  • Advanced Networking
  • FindMe
  • Device Provisioning
  • Conference Factory

Answer : Conference Factory

Which of the following statements is correct regarding the root account on a Cisco TelePresence VCS?


Options are :

  • The root account should be used for all administrative tasks.
  • An alarm is displayed if the root account is set to the default password.
  • You can log in to the root account only by using SSH or Telnet.
  • You can log in to the root account only by using a serial connection.

Answer : An alarm is displayed if the root account is set to the default password.

You enable FIPS mode on a Cisco TelePresence System Codec C60. Which of the following statements is not correct?


Options are :

  • The root user account is disabled.
  • Software upgrades are disabled
  • All calls will be encrypted.
  • Telnet and HTTP cannot be used.
  • IEEE 802.1x and SNMP are disabled.
  • The SIP Profile Type must be set to Microsoft.

Answer : The SIP Profile Type must be set to Microsoft.

642-732 Conducting Cisco Unified Wireless Site Survey Exam Set 1

Which of the following functions is not provided by Cisco MXE?


Options are :

  • media adaptation
  • media postproduction
  • media adaptation
  • video sharing and collaboration

Answer : video sharing and collaboration

Which of the following Cisco TelePresence VCS backup files would you be most likely to restore without a password?


Options are :

  • None of these files; all Cisco TelePresence VCS backup files require a password.
  • backupname.tar.gz
  • backupname.tar.gz.gz
  • backupname.tar.gz.enc

Answer : backupname.tar.gz

Which of the following is supported by MCUs deployed as media resources on Cisco Unified CM?


Options are :

  • TLS
  • BFCP
  • cascading
  • scheduled conferencing
  • ad hoc conferencing

Answer : ad hoc conferencing

200-310 Designing for Cisco Inter network Solutions Exam Set 5

You are attempting to connect a Cisco TelePresence Touch 8" to a codec. However, the codec is not listed in the pairing list on the touch screen. You have rebooted the codec and have initialized the touch screen. The touch screen has received IP addressing information from a DHCP server. The codec and the touch screen are on different subnets. Which of the following actions could you perform to enable the Touch 8" to connect to the codec? (Choose two.)


Options are :

  • Enable direct pairing on the codec, reboot the codec, and connect the touch screen directly to the codec.
  • Configure the touch screen with static IP address information
  • Enter the codec IP address or host name manually in the touch screen.
  • Enable pairing visibility mode on the codec.

Answer : Enable direct pairing on the codec, reboot the codec, and connect the touch screen directly to the codec. Configure the touch screen with static IP address information

Which of the following statements are correct regarding far-end camera control on an MX300? (Choose two.)


Options are :

  • You cannot control the camera by using the touch screen.
  • You must select the avatar of the participant in order to control that camera.
  • You can adjust the camera's pan, tilt, and zoom.
  • You can adjust the camera on only point-to-point calls.

Answer : You must select the avatar of the participant in order to control that camera. You can adjust the camera's pan, tilt, and zoom.

To which of the following would you connect a Cisco TelePresence PrecisionHD camera by using a VISCA cable?


Options are :

  • a Cisco C-series codec
  • another Cisco TelePresence PrecisionHD camera
  • a monitor or other video capture device
  • a UPS device

Answer : a Cisco C-series codec

ICND2 200-105 Certification Practice Tests Set 1

You do not have a password configured for the admin account on a Cisco SX20. Which of the following will appear on the Diagnostics > Troubleshooting page of the web interface?


Options are :

  • no alert
  • a yellow alert
  • a red alert
  • a green alert

Answer : a red alert

Which content-sharing protocol is negotiated for point-to-point meetings in a Cisco TelePresence environment with SIP?


Options are :

  • Auto-Collaborate
  • BFCP
  • H.239
  • Switched Presentation

Answer : BFCP

Which of the following features is not found on the Cisco TelePresence EX90 endpoint?


Options are :

  • dual-display support
  • Multiway
  • MultiSite
  • a 21.5inch HD display
  • Bluetooth

Answer : a 21.5inch HD display

400-101 CCIE Routing and Switching Written Practice Exam Set 4

Why should you restart a codec before attempting to connect a Cisco TelePresence Touch 8" to the codec over a LAN?


Options are :

  • Restarting enables the codec to assign IP address information
  • Restarting activates pairing visibility mode for 30 minutes.
  • Restarting activates direct pairing on the codec.
  • Restarting ensures that any problems with the codec are cleared

Answer : Restarting activates pairing visibility mode for 30 minutes.

To which of the following locations should you navigate on a Cisco TelePresence VCS if an administrator policy denies a call that should be allowed?


Options are :

  • Call Policy > Configuration
  • Registration > Deny List
  • Protocols > SIP > Configuration
  • Protocols > SIP > Domains

Answer : Call Policy > Configuration

Which of the following best describes the functionality of the xFeedback command group on a Cisco VCS?


Options are :

  • It enables you to modify the device configuration.
  • It provides historical information.
  • It provides system status information.
  • It provides real-time call information.

Answer : It provides real-time call information.

300-115 Implementing Cisco IP Switched Network Practice Exam Set 3

Which of the following conferencing features requires a Cisco VCS and a Cisco MCU?


Options are :

  • both MultiSite and Multiway
  • only Multiway
  • only MultiSite
  • neither MultiSite nor Multiway

Answer : only Multiway

Which of the following streaming methods of Windows Media content can be performed natively by Cisco TCS?


Options are :

  • only live unicast and live multicast streaming
  • only live unicast streaming
  • only on-demand streaming
  • only live unicast and on-demand streaming

Answer : only live unicast and on-demand streaming

Which of the following commands should you issue to check whether a camera is set for a forced upgrade the next time the system is restarted?


Options are :

  • show hardware all
  • show upgrade detail
  • show status
  • set upgrade camera

Answer : show upgrade detail

Cisco 210-060 Implement Collaboration Device Practice Exam Set 6

You want to set a static IP address on Port A of a Cisco TelePresence MCU 5300. You navigate to Network > Port A and configure the device with IP address 192.168.1.43, subnet mask 255.255.255.0, and default gateway 192.168.1.1. However, the device's IP address does not change. Which of the following statements correctly diagnoses the problem?


Options are :

  • You must reboot the Cisco MCU 5300.
  • You must change the default gateway.
  • You must change the subnet mask.
  • You must set the IP configuration to Manual.

Answer : You must set the IP configuration to Manual.

An H.323 endpoint attempts to register with a Cisco VCS by using an alias that has previously been registered from another IP address. Which of the following will occur if the Cisco VCS is configured with the default settings?


Options are :

  • The VCS will allow the new registration while maintaining the old registration.
  • The VCS will replace the old registration with the new registration.
  • The VCS will deny the new registration and maintain the old registration.
  • The VCS will deny the new registration and remove the old registration.

Answer : The VCS will deny the new registration and maintain the old registration.

Comment / Suggestion Section
Point our Mistakes and Post Your Suggestions