210-065 Implementing Cisco Video Network Devices Exam Set 3

Which of the following will not be affected when you issue the xCommand SystemUnit FactoryReset Confirm: Yes command on a Cisco TelePresence EX, MX, SX, or Cseries system? (Choose two.)


Options are :

  • release keys
  • custom backgrounds
  • local phonebook
  • certificates
  • call logs
  • option keys

Answer : release keys option keys

642-732 Conducting Cisco Unified Wireless Site Survey Exam Set 5

Which of the following QoS packet types should have the highest priority?


Options are :

  • network control
  • voice
  • transactional data
  • streaming video
  • interactive video

Answer : network control

Which of the following commands or command sets should you issue to configure a Cisco TelePresence System 1000 with IP address 192.168.1.43, subnet mask 255.255.255.0, and default gateway 192.168.1.1?


Options are :

  • set network ip static 192.168.1.43 255.255.255.0 192.168.1.1
  • xConfiguration Network 1 IPv4 Address: "192.168.1.43" xConfiguration Network 1 IPv4 SubnetMask: "255.255.255.0" xConfiguration Network 1 IPv4 Gateway: "192.168.1.1"
  • ip address 192.168.1.43 255.255.255.0 192.168.1.1
  • static 192.168.1.43 255.255.255.0 192.168.1.1

Answer : set network ip static 192.168.1.43 255.255.255.0 192.168.1.1

Which of the following is a minimum threshold condition that will cause a CTS to drop a call?


Options are :

  • 10 seconds of 1 percent packet loss
  • 60 seconds of 10 percent packet loss
  • 10 seconds of 100 percent packet loss
  • 180 seconds of 10 percent packet loss
  • 10 seconds of 10 percent packet loss

Answer : 180 seconds of 10 percent packet loss

200-105 Interconnecting Cisco Networking Devices Part Exam Set 1

On which of the following devices would you navigate to Menu > Advanced Settings > System Configuration SIP > Profile 1 > MultiWayConference in order to configure a Multiway address?


Options are :

  • Cisco TelePresence System EX60
  • Cisco IP Video Phone E20
  • Cisco TelePresence System C60
  • Cisco TelePresence System MXP

Answer : Cisco IP Video Phone E20

Which of the following commands will set a Cisco TelePresence System 500 to the factory default settings, including setting the boot slot to the factory slot?


Options are :

  • xCommand SystemUnit FactoryReset Confirm: Yes
  • utils system factory init
  • utils system factory reset
  • utils service restart
  • factory-reset
  • utils system restart

Answer : utils system factory reset

Which of the following video layout options are not recommended as of TC6.0? (Choose three.)


Options are :

  • Overlay
  • PresentationLargeSpeaker
  • Equal
  • PresentationSmallSpeaker
  • FullScreen
  • Auto

Answer : PresentationLargeSpeaker PresentationSmallSpeaker FullScreen

210-260 Implementing Cisco Network Security Practice Exam Set 8

Which of the following network diagnostic commands can be issued on a Cisco TelePresence System Codec C60? (Choose two.)


Options are :

  • utils network ping
  • systemtools network ping
  • systemtools network traceroute
  • utils network traceroute
  • utils network tracert

Answer : systemtools network ping systemtools network traceroute

Which codec is the default video compression format for most Cisco IP video endpoints?


Options are :

  • H.264
  • G.729
  • H.263
  • H.261
  • G.711

Answer : H.264

Which of the following devices are used for call control? (Choose two.)


Options are :

  • CTRS
  • Cisco Unified CM
  • Cisco TelePresence VCS
  • Cisco TMS

Answer : Cisco Unified CM Cisco TelePresence VCS

Cisco CCNP Route 300-101 Practice Tests Set 1

Which of the following endpoints is recommended for the largest number of participants?


Options are :

  • SX80
  • SX20
  • EX90
  • EX60

Answer : SX80

Which of the following endpoints can communicate by using Cisco TelePresence VCS?


Options are :

  • both SIP and H.323 endpoints
  • neither SIP nor H.323 endpoints
  • only H.323 endpoints
  • only SIP endpoints

Answer : both SIP and H.323 endpoints

For which of the following reasons is a red oval most likely to appear next to a contact in Cisco Jabber? (Choose two.)


Options are :

  • The user is sharing content.
  • The user is on a call.
  • The user does not want to be disturbed.
  • The user has been idle for a while.
  • The user has missed a call.

Answer : The user is on a call. The user does not want to be disturbed.

300-320 Designing Cisco Network Service Architectures Exam Set 2

You navigate to Configuration > System Configuration > SIP > Profile 1 > Authentication 1 on a Cisco TelePresence endpoint and configure a login name and password. To which of the following locations would you navigate on the Cisco TelePresence VCS in order to add the endpoint's credentials?


Options are :

  • Protocols > SIP > Domains
  • Registration > Allow List
  • Authentication > Devices > Local Database
  • Registration > Deny List
  • Registration > Configuration

Answer : Authentication > Devices > Local Database

Which of the following MCU logs cannot be downloaded to an XML file by using the web interface on a Cisco TelePresence MCU?


Options are :

  • the audit log
  • the event log
  • the H.323/SIP log
  • the call detail records

Answer : the event log

During a call, you discover that you are unable to control the remote camera from your Cisco TelePresence SX20 Quick Set endpoint. Which of the following reasons might cause this behavior to occur? (Choose two.)


Options are :

  • The Conference FarEndControl Mode setting on the remote system is set to Off.
  • The call is encrypted.
  • The remote camera does not have PTZ functionality.
  • The Conference FarEndControl Mode setting on your system is set to Off.

Answer : The Conference FarEndControl Mode setting on the remote system is set to Off. The remote camera does not have PTZ functionality.

Cisco Data Center Architecture Set 4

You have configured five devices on a group FindMe account. Three desk phones are configured as primary devices, a mobile phone is configured in the busy list, and a desktop endpoint is configured in the no-answer list. A user calls the FindMe ID when one of the desk phones associated with the ID is in use. Which of the following devices will ring?


Options are :

  • all of the devices
  • the other two desk phones
  • the desktop endpoint
  • the mobile phone

Answer : the other two desk phones

Which of the following statements is not correct regarding the Cisco TelePresence MCU?


Options are :

  • Cisco TelePresence MCU supports SIP as the signaling protocol.
  • Cisco TelePresence MCU can support multiple simultaneous conferences
  • Cisco TelePresence MCU delivers up to 1080p at 30 frames per second.
  • Cisco TelePresence MCU is a software conference bridge
  • Cisco TelePresence MCU supports ad-hoc and meet-me conferences.

Answer : Cisco TelePresence MCU is a software conference bridge

Which of the following must you do before performing a restore of a Cisco VCS cluster peer?


Options are :

  • Take a backup of the VCS peer.
  • Reboot the VCS peer.
  • Remove the VCS peer from the cluster.
  • Shut down the other devices in the cluster

Answer : Remove the VCS peer from the cluster.

300-101 Implementing Cisco IP Routing (ROUTE) Practice Exam Set 2

Which of the following actions are you are unable to perform from the Call Control tab on the Cisco Codec C40 web interface?


Options are :

  • selecting the wallpaper
  • controlling the volume
  • placing a point-to-point video call
  • displaying call statistics
  • controlling the camera
  • placing a MultiSite video call

Answer : selecting the wallpaper

Which of the following option keys is not required in order for the corresponding feature to function on a Cisco Codec C40?


Options are :

  • Presentation
  • MultiSite
  • Dual display
  • High definition

Answer : High definition

Which of the following statements best describes the functionality that is provided by Cisco Video Surveillance Virtual Matrix?


Options are :

  • It provides flexible control of video that can be delivered to any number of monitors.
  • It distributes, archives, and manages video streams, replicating those streams to viewers as needed.
  • It provides centralized configuration and administration of media servers, encoders, cameras, and users.
  • It is an all-in-one appliance that can encode, distribute, manage, and archive video feeds.

Answer : It provides flexible control of video that can be delivered to any number of monitors.

Cisco CCNP Route 300-101 Practice Tests Set 2

How many Cisco TelePresence Server MSE 8710 blades can be configured in a cluster?


Options are :

  • up to eight
  • two
  • up to 16
  • up to four

Answer : up to four

Which of the following tasks can you perform by issuing an xCommand command on a Cisco VCS? (Choose two.)


Options are :

  • create an IP route
  • ping a system
  • view authentication status information
  • view real-time call and registration information
  • create an administrator account

Answer : ping a system create an administrator account

Which of the following functions can you perform by selecting System > Navigator in Cisco TMS? (Choose three.)


Options are :

  • set folder and system permissions
  • restore a system configuration from a backup
  • view call status
  • create, modify, copy, and delete configuration templates
  • manage dial plans
  • add, replace, and purge systems

Answer : set folder and system permissions view call status add, replace, and purge systems

100-105 Net Cert Interconnecting Cisco Networking Exam Set 7

Which of the following DHCP options can be used to configure a Cisco TelePresence endpoint with the IP address of the TFTP server that contains its configuration file?


Options are :

  • option 51
  • option 6
  • option 150
  • option 3
  • option 66

Answer : option 150

Which of the following are correct regarding Cisco TCS? (Choose two.)


Options are :

  • Media server configurations are configured in a template.
  • A recording alias can be assigned to a template.
  • A template can be assigned to a recording alias.
  • A template can be assigned to a media server configuration.

Answer : Media server configurations are configured in a template. A template can be assigned to a recording alias.

Which System tab menu option is available in Cisco TMS only if Cisco TMSPE is installed and activated?


Options are :

  • Navigator
  • Provisioning
  • System Upgrade
  • Configuration Templates

Answer : Provisioning

200-105 Inter connecting Cisco Networking Devices Exam Set 1

Which of the following best describes compositing?


Options are :

  • combining video from a single source taken at two different times into a single image
  • displaying an entire video image in a single scan
  • combining two digital signals and alternating between them
  • combining video from multiple sources into a single image

Answer : combining video from multiple sources into a single image

Which of the following is an audio codec that provides high-quality audio output?


Options are :

  • H.261
  • H.263
  • G.711
  • G.729

Answer : G.711

Comment / Suggestion Section
Point our Mistakes and Post Your Suggestions