200-125 Cisco Certified Network Associate Practice Exam Set 9

Which protocol is an open standard protocol framework that is commonly used in VPNs, to provide secure end-to-end communications?


Options are :

  • L2TP
  • RSA
  • IPsec
  • PPTP

Answer : IPsec

210-065 Implementing Cisco Video Network Devices Exam Set 6

An administrator must assign static IP addresses to the servers in a network. For network 192.168.20.24/29, the router is assigned the first usable host address while the sales server is given the last usable host address. Which of the following should be entered into the IP properties box for the sales server?


Options are :

  • IP address: 192.168.20.254 Subnet Mask: 255.255.255.0 Default Gateway: 192.168.20.1
  • IP address: 192.168.20.30 Subnet Mask: 255.255.255.240 Default Gateway: 192.168.20.17
  • IP address: 192.168.20.30 Subnet Mask: 255.255.255.248 Default Gateway: 192.168.20.25
  • IP address: 192.168.20.14 Subnet Mask: 255.255.255.248 Default Gateway: 192.168.20.9
  • IP address: 192.168.20.30 Subnet Mask: 255.255.255.240 Default Gateway: 192.168.20.25

Answer : IP address: 192.168.20.30 Subnet Mask: 255.255.255.248 Default Gateway: 192.168.20.25

Which two statements about static NAT translations are true? (Choose two.)


Options are :

  • A,C
  • They allow connections to be initiated from the outside.
  • They require no inside or outside interface markings because addresses are statically defined.
  • They can be configured with access lists, to allow two or more connections to be initiated from the outside.
  • They are always present in the NAT table.

Answer : A,C

Which two statistics appear in show frame-relay map output? (Choose two.)


Options are :

  • the value of the local DLCI
  • the status of the PVC that is configured on the router
  • the number of FECN packets that are received by the router
  • B,D
  • the IP address of the local router
  • the number of BECN packets that are received by the router

Answer : B,D

210-065 Implementing Cisco Video Network Devices Exam Set 1

What is the first 24 bits in a MAC address called?


Options are :

  • NIC
  • VAI
  • OUI
  • BIA

Answer : OUI

Which two tasks does the Dynamic Host Configuration Protocol perform? (Choose two.)


Options are :

  • C,F
  • Provide an easy management of layer 3 devices.
  • Perform host discovery used DHCPDISCOVER message.
  • Monitor IP performance using the DHCP server.
  • Set the IP gateway to be used by the network.
  • Assign and renew IP address from the default pool.
  • Configure IP address parameters from DHCP server to a host.

Answer : C,F

Which command enables IPv6 forwarding on a Cisco router?


Options are :

  • ipv6 host
  • ipv6 unicast-routing
  • ipv6 neighbor
  • ipv6 local

Answer : ipv6 unicast-routing

400-101 CCIE Routing and Switching Written Practice Exam Set 2

Which option is a valid IPv6 address?


Options are :

  • 2004:1:25A4:886F::1
  • 2002:7654:A1AD:61:81AF:CCC1
  • FEC0:ABCD:WXYZ:0067::2A4
  • 2001:0000:130F::099a::12a

Answer : 2004:1:25A4:886F::1

What levels will be trapped if the administrator executes the command router(config)# logging trap 4 (Choose four)


Options are :

  • Notice
  • Alert
  • A,C,D,E
  • Warning
  • Error
  • Emergency

Answer : A,C,D,E

What are the alert messages generated by SNMP agents called?


Options are :

  • A,B
  • GET
  • SET
  • TRAP
  • INFORM

Answer : A,B

300-101 Implementing Cisco IP Routing (ROUTE) Practice Exam Set 3

What SNMP message alerts the manager to a condition on the network?


Options are :

  • response
  • trap
  • capture
  • get

Answer : trap

Given an IP address 172.16.28.252 with a subnet mask of 255.255.240.0, what is the correct network address?


Options are :

  • 172.16.0.0
  • 172.16.16.0
  • 172.16.28.0
  • 172.16.24.0

Answer : 172.16.16.0

Which two statements describe characteristics of IPv6 unicast addressing? (Choose two.)


Options are :

  • If a global address is assigned to an interface, then that is the only allowable address for the interface.
  • Link-local addresses start with FE00:/12.
  • Link-local addresses start with FF00::/10.
  • A,D
  • Global addresses start with 2000::/3.
  • There is only one loopback address and it is ::1.

Answer : A,D

100-105 Net Cert Interconnecting Cisco Networking Exam Set 4

Which three statements about Syslog utilization are true? (Choose three.)


Options are :

  • A Syslog server helps in aggregation of logs and alerts.
  • There are more Syslog messages available within Cisco IOS than there are comparable SNMP trap messages.
  • C,D,F
  • The Syslog server automatically notifies the network administrator of network problems.
  • A Syslog server provides the storage space necessary to store log files without using router disk space.
  • Enabling Syslog on a router automatically enables NTP for accurate time stamping.
  • Utilizing Syslog improves network performance.

Answer : C,D,F

What are three characteristics of satellite Internet connections? (Choose three.)


Options are :

  • They are usually at least 10 times faster than analog modem connections.
  • They use radio waves to communicate with cellular phone towers.
  • They require a WiMax tower within 30 miles of the user location.
  • They are usually faster than cable and DSL connections.
  • Their upload speed is about 10 percent of their download speed.
  • They are frequently used by rural users without access to other high-speed connections.
  • A,B,C

Answer : A,B,C

200-105 Inter connecting Cisco Networking Devices Exam Set 3

Which command sequence can you enter to create VLAN 20 and assign it to an interface on a switch?


Options are :

  • Switch(config)#vlan 20 Switch(config)#Interface vlan 20 Switch(config-if)#switchport trunk native vlan 20
  • Switch(config)#vlan 20 Switch(config)#Interface gig x/y Switch(config-if)#switchport access vlan 20
  • Switch(config)#Interface gig x/y Switch(config-if)#vlan 20 Switch(config-vlan)#switchport access vlan 20
  • Switch(config)#vlan 20 Switch(config)#Interface vlan 20 Switch(config-if)#switchport access vlan 20
  • Switch(config)#vlan 20 Switch(config)#Interface vlan 20 Switch(config-if)#switchport trunk allowed vlan 20

Answer : Switch(config)#vlan 20 Switch(config)#Interface gig x/y Switch(config-if)#switchport access vlan 20

In which circumstance are multiple copies of the same unicast frame likely to be transmitted in a switched LAN?


Options are :

  • when upper-layer protocols require high reliability
  • after broken links are re-established
  • during high traffic periods
  • when a dual ring topology is in use
  • in an improperly implemented redundant topology

Answer : in an improperly implemented redundant topology

Which two statements about northbound and southbound APIs are true? (Choose two.)


Options are :

  • Only southbound APIs allow program control of the network.
  • Both northbound and southbound APIs allow program control of the network.
  • Only northbound APIs allow program control of the network.
  • B,C
  • Both northbound and southbound API interfaces use a Service Abstraction Layer.
  • Only northbound API interfaces use a Service Abstraction Layer.
  • Only southbound API interfaces use a Service Abstraction Layer.

Answer : B,C

400-101 CCIE Routing and Switching Written Practice Exam Set 12

A network administrator is configuring ACLs on a Cisco router, to allow traffic from hosts on networks 192.168.146.0, 192.168.147.0, 192.168.148.0, and 192.168.149.0 only. Which two ACL statements, when combined, would you use to accomplish this task? (Choose two.)


Options are :

  • access-list 10 permit ip 192.168.146.0 255.255.255.0
  • access-list 10 permit ip 192.168.148.0 0.0.1.255
  • access-list 10 permit ip 192.168.146.0 0.0.0.255
  • A,C
  • access-list 10 permit ip 192.168.149.0 0.0.255.255
  • access-list 10 permit ip 192.168.146.0 0.0.1.255
  • access-list 10 permit ip 192.168.147.0 0.0.255.255

Answer : A,C

Which item represents the standard IP ACL?


Options are :

  • access-list 2500 deny tcp any host 192.168.1.1 eq 22
  • access list 101 deny tcp any host 192.168.1.1
  • access-list 50 deny 192.168.1.1 0.0.0.255
  • access-list 110 permit ip any any

Answer : access-list 50 deny 192.168.1.1 0.0.0.255

What can be done to secure the virtual terminal interfaces on a router? (Choose two.)


Options are :

  • D,E
  • Configure a virtual terminal password and login process.
  • Administratively shut down the interface.
  • Physically secure the interface.
  • Enter an access list and apply it to the virtual terminal interfaces using the access-class command.
  • Create an access list and apply it to the virtual terminal interfaces with the access-group command.

Answer : D,E

200-105 Interconnecting Cisco Networking Devices Part Exam Set 6

What are three factors a network administrator must consider before implementing Netflow in the network? (Choose three.)


Options are :

  • WAN encapsulation
  • where Netflow data will be sent
  • A,B,C
  • number of devices exporting Netflow data
  • port availability
  • SNMP version
  • CPU utilization

Answer : A,B,C

How does using the service password-encryption command on a router provide additional security?


Options are :

  • by configuring an MD5 encrypted key to be used by routing protocols to validate routing exchanges
  • by encrypting all passwords passing through the router
  • by automatically suggesting encrypted passwords for use in configuring the router
  • by requiring entry of encrypted passwords for access to the device
  • by encrypting passwords in the plain text configuration file

Answer : by encrypting passwords in the plain text configuration file

Which two statements about IPv6 and routing protocols are true? (Choose two.)


Options are :

  • A,B
  • Loopback addresses are used to form routing adjacencies.
  • EIGRP, OSPF, and BGP are the only routing protocols that support IPv6.
  • OSPFv3 was developed to support IPv6 routing.
  • Link-local addresses are used to form routing adjacencies.
  • EIGRPv3 was developed to support IPv6 routing.

Answer : A,B

300-101 Implementing Cisco IP Routing (ROUTE) Practice Exam Set 3

Which Cisco Catalyst feature automatically disables the port in an operational PortFast upon receipt of a BPDU?


Options are :

  • BPDU Filter
  • Root Guard
  • Backbone Fast
  • Up link Fast
  • BPDU Guard

Answer : BPDU Guard

What Cisco IOS feature can be enabled to pinpoint an application that is causing slow network performance?


Options are :

  • WCCP
  • SNMP
  • Netflow
  • IP SLA

Answer : Netflow

Which command can you enter to set the default route for all traffic to an interface?


Options are :

  • router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1
  • router(config-router)#default-information originate always
  • router(config)#ip route 0.0.0.0 255.255.255.255 GigabitEthernet0/1
  • router(config-router)#default-information originate

Answer : router(config)#ip route 0.0.0.0 0.0.0.0 GigabitEthernet0/1

Cisco 210-060 Implement Collaboration Device Practice Exam Set 5

What are the benefits of using Netflow? (Choose three.)


Options are :

  • Network Planning
  • Accounting/Billing
  • A,C,D
  • Network, Application & User Monitoring
  • Security Analysis

Answer : A,C,D

What are three features of the IPv6 protocol? (Choose three.)


Options are :

  • B,C,E
  • checksums
  • no broadcasts
  • plug-and-play
  • optional IPsec
  • complicated header
  • autoconfiguration

Answer : B,C,E

Which three statements about link-state routing are true? (Choose three.)


Options are :

  • OSPF is a link-state protocol.
  • RIP is a link-state protocol.
  • A,B,C
  • It uses split horizon.
  • Updates are sent to a broadcast address.
  • Routes are updated when a change in topology occurs.
  • Updates are sent to a multicast address by default.

Answer : A,B,C

ICND1 100-105 Certification Practice Tests Set 4

Comment / Suggestion Section
Point our Mistakes and Post Your Suggestions