200-125 Cisco Certified Network Associate Practice Exam Set 10

What is the first step in the NAT configuration process?


Options are :

  • Define global and local interfaces.
  • Define inside and outside interfaces.
  • Define IP address pools.
  • Define public and private IP addresses.

Answer : Define inside and outside interfaces.

A national retail chain needs to design an IP addressing scheme to support a nationwide network. The company needs a minimum of 300 sub-networks and a maximum of 50 host addresses per subnet. Working with only one Class B address, which of the following subnet masks will support an appropriate addressing scheme? (Choose two.)


Options are :

  • 255.255.255.0
  • B,E
  • 255.255.255.128
  • 255.255.255.224
  • 255.255.248.0
  • 255.255.252.0
  • 255.255.255.192

Answer : B,E

In which three ways is an IPv6 header simpler than an IPv4 header? (Choose three.)


Options are :

  • IPv6 uses an extension header instead of the IPv4 Fragmentation field.
  • IPv6 headers use a smaller Option field size than IPv4 headers.
  • IPv6 headers use the Fragment Offset field in place of the IPv4 Fragmentation field.
  • IPv6 headers eliminate the IPv4 Checksum field.
  • Unlike IPv4 headers, IPv6 headers have a fixed length.
  • A,B,C
  • IPv6 headers use a 4-bit TTL field, and IPv4 headers use an 8-bit TTL field.

Answer : A,B,C

Cisco CCNP Route 300-101 Practice Tests Set 1

What is the purpose of the POST operation on a router?


Options are :

  • enable a TFTP server
  • locate an IOS image for booting
  • set the configuration register
  • determine whether additional hardware has been added

Answer : determine whether additional hardware has been added

Which IPv6 header field is equivalent to the TTL?


Options are :

  • Scan Timer
  • Hop Limit
  • Flow Label
  • TTD
  • Hop Count

Answer : Hop Limit

What are three values that must be the same within a sequence of packets for Netflow to consider them a network flow? (Choose three.)


Options are :

  • egress interface
  • destination IP address
  • A,D,E
  • source MAC address
  • source IP address
  • ingress interface
  • IP next-hop

Answer : A,D,E

Cisco 210-060 Implement Collaboration Device Practice Exam Set 3

Which three circumstances can cause a GRE tunnel to be in an up/down state? (Choose three.)


Options are :

  • A valid route to the destination address is missing from the routing table.
  • The tunnel interface is down.
  • An ACL is blocking the outbound traffic.
  • The tunnel address is routed through the tunnel itself.
  • The tunnel interface IP address is misconfigured.
  • The ISP is blocking the traffic.
  • B,C,D

Answer : B,C,D

What will be the result if the following configuration commands are implemented on a Cisco switch? Switch(config-if)# switchport port-security Switch(config-if)# switchport port-security mac-address sticky


Options are :

  • A dynamically learned MAC address is saved in the VLAN database.
  • Statically configured MAC addresses are saved in the startup-configuration file if frames from that address are received.
  • A dynamically learned MAC address is saved in the running-configuration file.
  • A dynamically learned MAC address is saved in the startup-configuration file.
  • Statically configured MAC addresses are saved in the running-configuration file if frames from that address are received.

Answer : A dynamically learned MAC address is saved in the running-configuration file.

Which two features can dynamically assign IPv6 addresses? (Choose two.)


Options are :

  • DHCP
  • IPv6 stateful autoconfiguration
  • IPv6 stateless autoconfiguration
  • NHRP
  • ISATAP tunneling
  • A,B

Answer : A,B

210-260 Implementing Cisco Network Security Practice Exam Set 3

Which protocol can cause overload on a CPU of a managed device?


Options are :

  • SNMP
  • WCCP
  • IP SLA
  • Netflow

Answer : SNMP

Syslog was configured with a level 3 trap. Which 3 types of logs would be generated (choose four)


Options are :

  • Alerts
  • Warnings
  • Emergencies
  • Critical
  • Errors
  • A,B,C,D

Answer : A,B,C,D

What command visualizes the general NetFlow data on the command line?


Options are :

  • show ip flow top-talkers
  • show ip flow export
  • show mls sampling
  • show mls netflow ip
  • show ip cache flow

Answer : show ip cache flow

200-105 Inter connecting Cisco Networking Devices Exam Set 3

A network administrator enters the following command on a router: logging trap 3. What are three message types that will be sent to the Syslog server? (Choose three.)


Options are :

  • emergency
  • critical
  • debug
  • warning
  • informational
  • B,D,F
  • error

Answer : B,D,F

Which two Cisco IOS commands, used in troubleshooting, can enable debug output to a remote location? (Choose two)


Options are :

  • logging host ip-address
  • B,C
  • terminal monitor
  • no logging console
  • snmp-server enable traps syslog
  • show logging | redirect flashioutput.txt

Answer : B,C

If all OSPF routers in a single area are configured with the same priority value, what value does a router use for the OSPF router ID in the absence of a loopback interface?


Options are :

  • the IP address of the first Fast Ethernet interface
  • the priority value until a loopback interface is configured
  • the lowest IP address among its active interfaces
  • the IP address of the console management interface
  • the highest IP address among its active interfaces

Answer : the highest IP address among its active interfaces

200-310 Designing for Cisco Inter network Solutions Exam Set 5

What are two benefits of private IPv4 IP addresses? (Choose two.)


Options are :

  • They are routed the same as public IP addresses.
  • They are less costly than public IP addresses.
  • They eliminate duplicate IP conflicts.
  • They eliminate the necessity for NAT policies.
  • They can be assigned to devices without Internet connections.
  • A,C

Answer : A,C

Which two commands correctly verify whether port security has been configured on port FastEthernet 0/12 on a switch? (Choose two.)


Options are :

  • SW1#show switchport port-secure interface FastEthernet 0/12
  • SW1#show port-secure interface FastEthernet 0/12
  • SW1#show running-config
  • C,D
  • SW1#show switchport port-security interface FastEthernet 0/12
  • SW1#show port-security interface FastEthernet 0/12

Answer : C,D

What are the three things that the Netflow uses to consider the traffic to be in a same flow? (Choose three)


Options are :

  • MAC address
  • IP address
  • L3 protocol type
  • A,C,D
  • Interface name
  • Port numbers

Answer : A,C,D

300-320 Designing Cisco Network Service Architectures Exam Set 6

Which two statements about using leased lines for your WAN infrastructure are true? (Choose two.)


Options are :

  • Leased lines with sufficient bandwidth can avoid latency between endpoints.
  • C,D
  • Leased lines provide highly flexible bandwidth scaling.
  • Multiple leased lines can share a router interface.
  • Leased lines provide inexpensive WAN access.
  • Leased lines require little installation and maintenance expertise.
  • Leased lines support up to T1 link speeds.

Answer : C,D

Which two security appliances will you use in a network? (Choose two.)


Options are :

  • ATM
  • B,E
  • SDM
  • IPS
  • IOS
  • IOX
  • IDS

Answer : B,E

Which router IOS commands can be used to troubleshoot LAN connectivity problems? (Choose three.)


Options are :

  • ipconfig
  • winipcfg
  • show interfaces
  • ping
  • A,D,F
  • tracert
  • show ip route

Answer : A,D,F

ICND1 100-105 Certification Practice Tests Set 2

In GLBP, which router will respond to client ARP requests?


Options are :

  • All GLBP member routers will reply in round-robin fashion.
  • The active virtual gateway will reply with its own hardware MAC address.
  • The GLBP member routers will reply with one of four possible burned in hardware addresses.
  • The active virtual gateway will reply with one of four possible virtual MAC addresses.

Answer : The active virtual gateway will reply with one of four possible virtual MAC addresses.

Which two commands can you enter to verify that a configured NetFlow data export is operational? (Choose two.)


Options are :

  • ip flow ingress
  • show ip flow export
  • ip flow egress
  • A,B
  • ip flow-export destination
  • show ip cache flow
  • interface ethernet 0/0

Answer : A,B

What Netflow component can be applied to an interface to track IPv4 traffic?


Options are :

  • flow exporter
  • flow monitor
  • flow sampler
  • flow record

Answer : flow monitor

200-125 Cisco Certified Network Associate Practice Exam Set 4

Which statement about access lists that are applied to an interface is true?


Options are :

  • You can apply only one access list on any interface.
  • You can place as many access lists as you want on any interface.
  • You can configure one access list, per direction, per Layer 3 protocol.
  • You can apply multiple access lists with the same protocol or in different directions.

Answer : You can configure one access list, per direction, per Layer 3 protocol.

A network administrator needs to configure port security on a switch. Which two statements are true? (Choose two.)


Options are :

  • The network administrator can apply port security to EtherChannels.
  • The network administrator can apply port security to dynamic access ports.
  • When dynamic MAC address learning is enabled on an interface, the switch can learn new addresses, up to the maximum defined.
  • The sticky learning feature allows the addition of dynamically learned addresses to the running configuration.
  • C,D
  • The network administrator can configure static secure or sticky secure MAC addresses in the voice VLAN.

Answer : C,D

What are two benefits of using NAT? (Choose two.)


Options are :

  • NAT protects network security because private networks are not advertised.
  • NAT accelerates the routing process because no modifications are made on the packets.
  • Dynamic NAT facilitates connections from the outside of the network.
  • NAT eliminates the need to re-address all hosts that require external access.
  • NAT conserves addresses through host MAC-level multiplexing.
  • B,F
  • NAT facilitates end-to-end communication when IPsec is enabled.

Answer : B,F

100-105 Net Cert Interconnecting Cisco Networking Exam Set 4

In which two formats can the IPv6 address fd15:0db8:0000:0000:0700:0003:400F:572B be written? (Choose two.)


Options are :

  • fd15:0db8:0000:0000:700:3:400F:527B
  • fd15::db8::700:3:400F:527B
  • fd15:db8:0::700:3:4F:527B
  • fd15:db8::700:3:400F:572B
  • D,E
  • fd15:0db8::7:3:4F:527B

Answer : D,E

When you are troubleshooting an ACL issue on a router, which command would you use to verify which interfaces are affected by the ACL?


Options are :

  • list ip interface
  • show ip interface
  • show ip access-lists
  • show interface
  • show access-lists

Answer : show ip interface

Which set of commands is recommended to prevent the use of a hub in the access layer?


Options are :

  • switch(config-if)#switchport mode access switch(config-if)#switchport port-security maximum 1
  • switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security mac-address 1
  • switch(config-if)#switchport mode access switch(config-if)#switchport port-security mac-address 1
  • switch(config-if)#switchport mode trunk switch(config-if)#switchport port-security maximum 1

Answer : switch(config-if)#switchport mode access switch(config-if)#switchport port-security maximum 1

210-065 Implementing Cisco Video Network Devices Exam Set 5

Comment / Suggestion Section
Point our Mistakes and Post Your Suggestions