200-105 Inter connecting Cisco Networking Devices Exam Set 2

Which of the following statements describes split horizon?


Options are :

  • The moment a router determines a route has gone down, it will immediately send a route update with an infinite metric to that route.
  • A router will not send route information back out the same interface over which it was learned.
  • For a period of time, the router will ignore any route advertisements with a lower metric to a downed route.
  • The router learns from its neighbor that a route has gone down, and the router sends an update back to the neighbor with an infinite metric to that route.

Answer : A router will not send route information back out the same interface over which it was learned.

Which command enables HSRP on an interface?


Options are :

  • standby ip
  • hsrp
  • standby mode hsrp
  • switchport mode hsrp

Answer : standby ip

Cisco 210-060 Implement Collaboration Device Practice Exam Set 5

Which of the following commands would instruct OSPF to advertise ONLY the 192.168.10.0/24 network in Area 0?


Options are :

  • Router(config)# router ospf 1Router(config-router)# network 192.168.10.0 0.0.255.255 area 0
  • Router(config)# router ospf 1Router(config-router)# network 192.168.10.0 0.0.0.255 area 0
  • Router(config)# router ospf 1Router(config-router)# network 192.168.10.0 255.255.255.0 area 0
  • Router(config)# router ospf 1 Router(config-router)# network 192.168.11.0 0.0.0.255 area 0

Answer : Router(config)# router ospf 1Router(config-router)# network 192.168.10.0 0.0.0.255 area 0

Which Enhanced Interior Gateway Routing Protocol (EIGRP) packet type is used for neighbor discovery?


Options are :

  • Queries
  • Update
  • Replies
  • Hello

Answer : Hello

Which of the following is NOT true of APIC-EM?


Options are :

  • It provides a single point for network automation
  • It is open and programmable
  • It saves time and cost
  • It supports greenfield but not brownfield deployments

Answer : It supports greenfield but not brownfield deployments

100-105 Net Cert Interconnecting Cisco Networking Exam Set 7

On Cisco switches, what is the correct order of port transition through the Spanning Tree Protocol (STP) states?


Options are :

  • blocking, learning, forwarding, listening
  • blocking, listening, learning, forwarding
  • learning, listening, blocking, forwarding
  • listening, blocking, forwarding, learning

Answer : blocking, listening, learning, forwarding

What command would be used to verify trusted DHCP ports?


Options are :

  • show ip trust
  • show mls qos
  • show ip arp trust
  • show ip dhcp snooping

Answer : show ip dhcp snooping

Which of the following is NOT true of the Cisco APIC-EM?


Options are :

  • It can verify the operation of access lists
  • It is appropriate for the datacenter environment
  • It provides network topology visualization
  • It can perform identity tracking

Answer : It is appropriate for the datacenter environment

200-125 Cisco Certified Network Associate Practice Exam Set 8

Which Wide Area Network (WAN) switching technology is used by Asynchronous Transfer Mode (ATM)?


Options are :

  • cell switching
  • packet switching
  • virtual switching
  • circuit switching

Answer : cell switching

When a router has been configured with a loopback address, which of the following determines the OSPF router ID?


Options are :

  • The lowest IP address assigned to a physical interface on the router
  • The highest MAC address assigned to a physical interface on the router
  • The highest IP address assigned to a loopback interface on the router
  • The lowest priority of a physical interface on the router

Answer : The highest IP address assigned to a loopback interface on the router

Which switch will be selected as the root bridge by Spanning Tree Protocol (STP)?


Options are :

  • switch with lowest number of root ports
  • switch with lowest IP address
  • switch with lowest bridge ID
  • switch with lowest Media Access Control (MAC) address

Answer : switch with lowest bridge ID

Cisco Data Center Architecture Set 5

Which of the following is NOT a packet type used by Enhanced Interior Gateway Routing Protocol (EIGRP)?


Options are :

  • Query
  • Reply
  • Ack
  • Response

Answer : Response

Which of the following statements is NOT true of Cisco ACI?


Options are :

  • It uses Cisco APIC as the central management system.
  • It is a comprehensive SDN architecture.
  • It provides policy driven automation support.
  • It decreases network visibility.

Answer : It decreases network visibility.

What is the HSRP virtual router MAC address for the virtual router for HSRP group 31?


Options are :

  • ac1f
  • 0c07
  • 07.ac
  • 0000.0c07.ac1f

Answer : 0000.0c07.ac1f

200-310 Designing for Cisco Inter network Solutions Exam Set 2

You would like for Router25 in your OSPF network to become the DR. You execute the show ip ospf interface command, receiving the output shown below. Router25# show ip ospf interface Ethernet0 is up, line protocol is up Internet Address 10.10.10.1/24, Area 0 Process ID 1,Router ID 10.10.10.1, Network Type BROADCAST, Cost: 10 Transmit Delay is 1 sec, State BDR, Priority 1 Designated Router (ID) 172.16.10.1, Interface address 10.10.10.2 Backup Designated router(ID)10.10.10.1,Interface address 10.10.10.1 You assign an IP address of 192.168.5.6 to the Ethernet1 interface of Router25 and enable the interface. However, Router25 does NOT become the designated router. What additional command must you execute to cause Router25 to become the DR?


Options are :

  • Router25(config-router)# network 192.168.5.0 0.0.0.255 area 1
  • Router25(config-router)# network 192.168.5.0 0.0.0.255 area 0
  • Router25(config)# network 192.168.5.0 0.0.0.255 area 0
  • Router25(config-router)# network 192.168.5.0 255.255.255.0 area 0

Answer : Router25(config-router)# network 192.168.5.0 0.0.0.255 area 0

Which of the following is NOT a characteristic of Open Shortest Path First (OSPF)?


Options are :

  • Is a Cisco-proprietary routing protocol
  • Uses cost as the default metric
  • Supports authentication
  • Has a default administrative distance of 110

Answer : Is a Cisco-proprietary routing protocol

You are configuring SPAN so you can connect a sniffer to your switch. Which of the following is NOT true with regard to the source port in the configuration?


Options are :

  • It can be monitored in multiple SPAN sessions
  • It can monitor both ingress and egress traffic
  • It can also be the destination port
  • It can be an EtherChannel

Answer : It can also be the destination port

100-105 Net Cert Interconnecting Cisco Networking Exam Set 2

Which of the following statements are TRUE regarding EIGRP operation? (Choose two.)


Options are :

  • A feasible successor is a backup route, and is installed in both the routing and topology tables.
  • A successor is a primary route, and is installed in both the routing and topology tables.
  • A successor is a primary route, and is installed only in the routing table
  • A feasible successor is a backup route, and is only installed in the topology table.
  • A feasible successor is a primary route, and is only installed in the routing table.
  • A successor is a backup route, and is installed in both the routing and topology tables

Answer : A successor is a primary route, and is installed in both the routing and topology tables. A feasible successor is a backup route, and is only installed in the topology table.

Which of the following technologies allows a switch port to immediately transition to a forwarding state?


Options are :

  • PortFast
  • Rapid STP
  • CDP
  • VTP

Answer : PortFast

Which of the following is NOT a benefit of cloud computing to cloud users?


Options are :

  • Cost reduction from standardization and automation
  • Highly available, horizontally scaled applications
  • Centralized appearance of resources
  • On-demand self-service resources provisioning

Answer : Cost reduction from standardization and automation

100-105 Net Cert Interconnecting Cisco Networking Exam Set 8

Which Cisco IOS command configures the clock rate to 64,000 bits per second on an interface?


Options are :

  • clock-rate 64000
  • clock rate 64000
  • clock rate 64k
  • clock rate 64000

Answer : clock rate 64000

200-125 Cisco Certified Network Associate Practice Exam Set 7

Which of the following is NOT a dynamic table maintained by a router running the EIGRP routing protocol?


Options are :

  • routing table
  • CAM table
  • neighbor table
  • topology table

Answer : CAM table

What command disables 802.1x authentication on a port and permits traffic without authentication?


Options are :

  • dot1x port-control auto
  • dot1x port-control force-unauthorized
  • dot1x port-control force-authorized
  • dot1x port-control disable

Answer : dot1x port-control force-authorized

You instructed your assistant to add a new router to the network. The routers in your network run OSPF. The existing router, OldRouter, is configured as follows: router ospf 1 network 192.168.5.0 0.0.0.255 area 0 network 192.168.10.0 0.0.0.255 area 0 The OldRouter interface that connects to NewRouter is 192.168.5.3/24. Your assistant shows you the configuration that will be implemented: newrouter(config)# router ospf 1 newrouter(config-router)# network 192.168.5.0 255.255.255.0 area 0 What is wrong with this configuration?


Options are :

  • The wildcard mask is incorrectly configured.
  • The area ID is incorrectly configured.
  • The process ID number is incorrectly configured.
  • The network statement is incorrectly configured.

Answer : The wildcard mask is incorrectly configured.

300-320 Designing Cisco Network Service Architectures Exam Set 6

Which command was used to generate the following output? P 172.16.16.0/24, 1 successors, FD is 284244 via 172.16.250.2 (284244/17669856), Serial0/0 via 172.16.251.2 (12738176/27819002), Serial0/1 P 172.16.250.0/24, 1 successors, FD is 2248564 via Connected, Serial0/0 P 172.16.10.0/24 1 successors, FD is 284244 via 172.16.50.1 (284244/17669856), Serial1/0


Options are :

  • show ip eigrp topology
  • show eigrp topology
  • show eigrp ip topology
  • show ip route eigrp

Answer : show ip eigrp topology

What command produced the following as a part of its output? 1 14.0.0.2 4 msec 4 msec 4 msec 2 63.0.0.3 20 msec 16 msec 16 msec 3 33.0.0.4 16 msec * 16 msec


Options are :

  • Ping
  • Extended ping
  • Traceroute
  • Tracert

Answer : Traceroute

Which of the following statements is NOT true with respect to using SPAN for troubleshooting?


Options are :

  • By default both received and transmitted traffic is captured
  • The destination port can receive both normal traffic and monitored traffic
  • The source port cannot also be a destination port
  • In the command monitor session 55 source interface Fa0/1, the value 55 is the session number

Answer : The destination port can receive both normal traffic and monitored traffic

300-320 Designing Cisco Network Service Architectures Exam Set 6

You are configuring a serial link between a Cisco router and a router produced by another vendor. What would be the advantages of using Point to Point Protocol (PPP) over High Level Data Link Control (HDLC) in this scenario?


Options are :

  • HDLC has a proprietary "type" field that may be incompatible with equipment from other vendors.
  • PPP performs error checking.
  • HDLC is not available on non-Cisco routers.
  • PPP is faster.

Answer : HDLC has a proprietary "type" field that may be incompatible with equipment from other vendors.

Enhanced Interior Gateway Routing Protocol (EIGRP) uses which algorithm to select the best path to the destination?


Options are :

  • Dijkstra algorithm
  • Shortest Path First (SPF) algorithm
  • Diffusing Update Algorithm (DUAL)
  • Bellman-Ford algorithm

Answer : Diffusing Update Algorithm (DUAL)

Router 5 has four interfaces. The networks hosted on each interface are as follows: Fa0/1 192.168.5.4/29 Fa0/2 192.168.6.0/24 Fa0/3 192.168.7.0/24 S0/0 172.16.5.0/24 You execute the following commands on the router: Router5(config)# router bgp 20 Router5(config-router)# network 192.168.5.0 Router5(config-router)# network 192.168.6.0 Router5(config-router)# network 192.168.7.0 Router5(config-router)# network 172.16.5.0 Router5(config-router)# neighbor 172.16.5.2 remote-as 50 Router5(config-router)# aggregate-address 192.168.5.0 255.255.252.0 After this command sequence is executed, what routes will be present in the routing table of the router at 172.16.5.2? (Choose all that apply.)


Options are :

  • 192.168.7.0/24
  • 192.168.5.4/29
  • 172.16.5.0/24
  • 192.168.6.0/24
  • none of these will be present

Answer : 192.168.7.0/24 192.168.5.4/29 172.16.5.0/24 192.168.6.0/24

300-101 Implementing Cisco IP Routing (ROUTE) Practice Exam Set 3

Comment / Suggestion Section
Point our Mistakes and Post Your Suggestions