100-105 Net Cert Interconnecting Cisco Networking Exam Set 8

Which media access control method is used by Ethernet technology to minimize collisions in the network?


Options are :

  • CSMA/CD
  • token passing
  • full-duplex
  • back-on algorithm

Answer : CSMA/CD

What filtering criteria does a standard IP access list use to filter packets?


Options are :

  • source IP address of the packets
  • Layer 4 protocol in use
  • destination IP address of the packets and Layer 4 protocol
  • IP address of the router on which access list is applied

Answer : source IP address of the packets

A router is running several routing protocols, and as a result has learned three routes to the 192.168.5.0 network. Below are the details about the three learned routes: Routing Protocol Cost RIP 5 OSPF 25 EIGRP 2269571 Based on this information, which route will be placed in the routing table?


Options are :

  • the EIGRP route
  • the RIP route
  • all of the routes
  • the OSPF route

Answer : the EIGRP route

Cisco 300-209 Implementing Secure Mobility Solutions Exam Set 7

You are attempting to add an IP address to an interface on a router with which you are unfamiliar. You type the following command and receive the following error: Router78(config)#interfce Serial0 ^ %invalid input detected at '^' marker. Which of the following could be a reason for receiving this message?


Options are :

  • the interface type does not exist on this router
  • the command syntax is incorrect
  • the interface is configured already
  • the command is entered at the wrong promp

Answer : the command syntax is incorrect

On a Cisco 2950 switch, which status LED and color combination indicates a Power On Self Test (POST) failure?


Options are :

  • system LED: solid red
  • stat LED: no color
  • system LED: no color
  • system LED: solid amber

Answer : system LED: solid amber

Which type of Category 5 unshielded twisted-pair (UTP) cable is used to work as a trunk between two switches?


Options are :

  • RJ-41 crossover
  • RJ-11 straight-through
  • RJ-45 straight-through
  • RJ-45 crossover

Answer : RJ-45 crossover

210-065 Implementing Cisco Video Network Devices Exam Set 6

Which Cisco Internetwork Operating System (IOS) command will you use to view the details of each interface on a router?


Options are :

  • show controllers
  • show interfaces ethernet
  • show ip interface brief
  • show interfaces loopback

Answer : show ip interface brief

Which of the following splits the network into separate broadcast domains?


Options are :

  • hubs
  • VLANs
  • switches
  • bridges

Answer : VLANs

The following shows the partial output of the show cdp neighbors command: DevicID Local Intrfce Holdtme Capability Platform Port ID lab-7206 Eth 0 157 R 7206VXR Fas 0/0/0 lab-as5300-1 Eth 0 163 R AS5300 Fas 0 lab-as5300-2 Eth 0 159 R AS5300 Eth 0 lab-as5300-3 Eth 0 122 R AS5300 Eth 0 lab-as5300-4 Eth 0 132 R AS5300 Fas 0/0 lab-3621 Eth 0 140 R S 3631-telcoFas 0/0 008024 2758E0 Eth 0 132 T CAT3000 1/2 lab-400-1 Eth 0 130 r FH400 Fas 0/0 What does "r" represent in this output?


Options are :

  • Hub
  • Route bridge
  • Repeater
  • Router

Answer : Repeater

400-101 CCIE Routing and Switching Written Practice Exam Set 7

Which Cisco Internetwork Operating System (IOS) command is used to view information about the Dynamic Host Configuration Protocol (DHCP) address pool?


Options are :

  • show ip dhcp server statistics
  • show dhcp pool
  • show ip dhcp server pool
  • show ip dhcp pool

Answer : show ip dhcp server pool

Which three statements are TRUE regarding a Local Area Network (LAN)? (Choose three.)


Options are :

  • A LAN is easily expandable.
  • A LANis confined to one building or campus.
  • A LAN provides fast data transmission.
  • A LAN can cover great distances.

Answer : A LAN is easily expandable. A LANis confined to one building or campus. A LAN provides fast data transmission.

Which Cisco IOS command is used on a Catalyst 2950 series switch to verify the port security configuration of a switch port?


Options are :

  • show interfaces switchport
  • show ip interface
  • show port-security interface
  • show interfaces port-security

Answer : show port-security interface

Cisco CCNP Route 300-101 Practice Tests Set 3

Which command is used on a Catalyst 2950 series switch to enable basic port security on the interface?


Options are :

  • set port-security
  • set port-security enable
  • switchport port-security enable
  • switchport port-security

Answer : switchport port-security

What is the term used for the Ethernet communication mechanism by which hosts can send and receive data simultaneously?


Options are :

  • half-duplex
  • full-duplex
  • duplex
  • multiplex

Answer : full-duplex

You are the network administrator for your company. You want to use both IPv6 and IPv4 applications in the network. You also want to ensure that routers can route both IPv6 and IPv4 packets. Which deployment model should be implemented to accomplish the task?


Options are :

  • Protocol translation
  • IPv6 over IPv4 tunnels
  • Dual-Stack Backbones
  • IPv6 over dedicated Wide Area Network (WAN) links

Answer : Dual-Stack Backbones

300-320 Designing Cisco Network Service Architectures Exam Set 6

Which cable can suffer attenuation if it is bent beyond the minimum bend radius?


Options are :

  • STP
  • UTP
  • Co-axial
  • Fiber optic

Answer : Fiber optic

Which of the following statements is NOT true regarding flow control?


Options are :

  • It manages the data transmission between devices.
  • It can help avoid network congestion.
  • It determines the rate at which the data is transmitted between the sender and receiver.
  • It uses a cyclic redundancy check (CRC) to identify and remove corrupted data

Answer : It uses a cyclic redundancy check (CRC) to identify and remove corrupted data

Which Cisco Internetwork Operating System (IOS) command is used to assign a router a name for identification?


Options are :

  • description
  • banner motd
  • hostname
  • banner exec

Answer : hostname

400-101 CCIE Routing and Switching Written Practice Exam Set 3

You have a class C address range and are planning a network that has an average of 50 hosts per subnet. How many host bits will have to be borrowed for subnetting so that the maximum number of subnets can be implemented?


Options are :

  • 2
  • 1
  • 3
  • 4

Answer : 2

Which two modes are Cisco Internetwork Operating System (IOS) operating modes? (Choose two.)


Options are :

  • User EXEC mode
  • User Privileged mode
  • Global configuration mode
  • NVRAM monitor mode
  • Local configuration mode

Answer : User EXEC mode Global configuration mode

Which command is used to disable Cisco Discovery Protocol (CDP) on a Cisco router?


Options are :

  • no cdp enable
  • disable cdp
  • no cdp advertise-v2
  • no cdp run

Answer : no cdp run

200-125 Cisco Certified Network Associate Practice Exam Set 9

Which of the following is the wildcard (inverse) version of a /27 mask?


Options are :

  • 0.0.0.7
  • 0.0.0.63
  • 0.0.0.31
  • 0.0.0.15

Answer : 0.0.0.31

Which Cisco 2950 switch command or set of commands would be used to create a Virtual LAN (VLAN) named MARKETING with a VLAN number of 25?


Options are :

  • switch(config)# vlan 25switch(config-vlan)# name MARKETING
  • switch(config)# vtp domain MARKETING 25
  • switch(config)# vtp 25switch(config-vtp)# name MARKETING
  • switch(config-if)# vlan 25 name MARKETING

Answer : switch(config)# vlan 25switch(config-vlan)# name MARKETING

Which statement is NOT true regarding Internet Control Message Protocol (ICMP)?


Options are :

  • An ICMP echo-request message is generated by the ping command.
  • ICMP can identify network problems.
  • ICMP is documented in RFC 792.
  • ICMP provides reliable transmission of data in an Internet Protocol (IP) environment.

Answer : ICMP provides reliable transmission of data in an Internet Protocol (IP) environment.

Cisco 210-060 Implement Collaboration Device Practice Exam Set 2

Which of these applications uses the IMAP protocol to transfer information between a server and a host?


Options are :

  • Telnet
  • Web browser
  • FTP
  • E-mail

Answer : E-mail

Which of the following IPV6 commands is used to define a static host name-to-address mapping in the host name cache?


Options are :

  • ipv6 unicast routing
  • ipv6 host
  • . ipv6 local
  • ipv6 neighbor

Answer : ipv6 host

Which statements are TRUE regarding Internet Protocol version 6 (IPv6) addresses? (Choose three.)


Options are :

  • IPv6 addresses are 196 bits in length.
  • An IPv6 address is divided into eight 16-bit groups.
  • Leading zeros cannot be omitted in an IPv6 address.
  • Groups with a value of 0 can be represented with a single 0 in IPv6 address.
  • A double colon (::) can only be used once in a single IPv6 address.

Answer : An IPv6 address is divided into eight 16-bit groups. Groups with a value of 0 can be represented with a single 0 in IPv6 address. A double colon (::) can only be used once in a single IPv6 address.

200-105 Interconnecting Cisco Networking Devices Part Exam Set 3

What is the broadcast address for subnet 172.25.4.0/23?


Options are :

  • 172.25.6.255
  • 172.25.7.255
  • 172.25.4.255
  • 172.25.5.255

Answer : 172.25.5.255

Which commands could you use to verify that a newly created access list that prevents Telnet and ICMP access to a server is set on the router? (Choose all that apply.)


Options are :

  • show access-group
  • show ip interface
  • show access-lists
  • show ip access lists

Answer : show ip interface show access-lists

You are configuring all your devices for IPv6. Which of the following is the only device that requires the ipv6 unicast-routing command?


Options are :

  • Layer 2 switch
  • Wireless AP
  • Router
  • Adaptive security appliance

Answer : Router

200-125 Cisco Certified Network Associate Practice Exam Set 11

Comment / Suggestion Section
Point our Mistakes and Post Your Suggestions