400-101 CCIE Routing and Switching Written Practice Exam Set 5

Which of the following statements is true regarding HSRPv2 and HSRPv6? (Choose the best answer.)


Options are :

  • The use of the same virtual MAC address range
  • Both use the same multicast address.
  • Both support groups 4096
  • Use the same UDP port number.
  • None

Answer :Both support groups 4096

400-101 CCIE Routing and Switching Written Practice Exam Set 8

Which of the following aircraft is responsible for the exchange of routing information and the label? (Choose the best answer.)


Options are :

  • data plane
  • control level
  • the forwarding plane
  • the management machine
  • routing information to the machine

Answer :control level

Which of the following is true concerning the structure of the VPN ID? (Choose the best answer.)


Options are :

  • It starts with 8-byte RD and ends at 4-byte IPv4 address.
  • It starts with 4-byte IPv4 address and ends at 3-byte OUI.
  • None
  • It starts with 3-byte OUI and ends at 4-byte VPN index.
  • It starts with 4-byte VPN index, and terminated with a 6-byte MAC address.

Answer :It starts with 3-byte OUI and ends at 4-byte VPN index.

Which of the following is true regarding the RTC? (Choose the best answer.)


Options are :

  • RTC operates only VPNv4.
  • RTC makes ABR RR and set the next hop for yourself
  • RTC find a route inconsistencies.
  • RTC synchronizes peers without a hard reset.
  • RTC sends only the prefixes that the PE router wants.

Answer :RTC sends only the prefixes that the PE router wants.

400-101 CCIE Routing and Switching Written Practice Exam Set 3

Which of the following is optional, nontransitive BGP path attribute? (Choose the best answer.)


Options are :

  • collector
  • origin
  • originator ID
  • AS-path
  • None

Answer :originator ID

What restrictions on OSPF virtual link creation? (Choose 3 options.)


Options are :

  • Transit area can not be a stub area.
  • The routers at both ends of the virtual link is a common area
  • One of the router is connected to the backbone area.
  • The load-bearing router at the far end of the virtual link not connect to the stub area.

Answer :Transit area can not be a stub area. The routers at both ends of the virtual link is a common area One of the router is connected to the backbone area.

Which of the following gives antireplay to protect members of the GET VPN Group? (Choose the best answer.)


Options are :

  • .TSK
  • KEK
  • None
  • SAR
  • TEK

Answer :SAR

400-101 CCIE Routing and Switching Written Practice Exam Set 9

Which of the following types of ICMPv6 message is used to query the link layer address of the host? (Choose the best answer.)


Options are :

  • router solicitation
  • None
  • neighbor solicitation
  • a router advertisement
  • a neighbor advertisement

Answer :a neighbor advertisement

Which of the following statements best describes the purpose of the holder timers? (Choose the best answer.)


Options are :

  • Holder RIP timers are used to determine the time to wait before removing a route therouting table.
  • None
  • Holder RIP timers are used to determine the time to suppress information abetter trail route.
  • Holder timers used by OSPF to determine the time to wait before declaring a neighbor down Tobe.
  • The holder OSPF timers used to determine the time between sending the hello packets

Answer :Holder RIP timers are used to determine the time to suppress information abetter trail route.

The following types of LSA contains information subnets and routers, all routers in the segment? (Choose the best answer.)


Options are :

  • Type 5
  • Type 2
  • None
  • Type 3
  • Type 1

Answer : Type 2

OSPF routing of the following indicators seeds are given to EIGRP default again? (Choose the best answer.)


Options are :

  • 1
  • None
  • 20
  • 0
  • endless

Answer : endless

400-101 CCIE Routing and Switching Written Practice Exam Set 3

IP as you grant access path list 1 permit ^ [09] * _ $ 222 command BGP router. Which path allows AS path filter? (Choose the best answer.)


Options are :

  • None
  • AS 222 and a path from any direct connection from the study
  • Additional to the AS 222 and AS .paths learned directly to a number 0 to 9
  • Route, learn AS 222 and AS directly attached numbered 0 through 9
  • Route, which is derived from AS 222 and AS 222 or for direct connection to the AS 222 AS

Answer : Route, which is derived from AS 222 and AS 222 or for direct connection to the AS 222 AS

How often repeated IP SLA operation, if it is not specified how often? (Choose the best answer.)


Options are :

  • None
  • Every 60 seconds
  • .IP SLA operation will not be repeated, if the frequency has not been determined.
  • Every five seconds
  • Every 300 seconds

Answer : Every 60 seconds

Which of the following after the command causes the value of the variable _exit_status EEM inspection, the applet is ready? (Choose the best answer.)


Options are :

  • 1 is set to 0 _exit_status
  • Event CLI mode "show IP interface brief" out of sync does not cover
  • Event CLI mode "show IP interface brief" synchronization
  • Event CLI mode "show IP interface brief" synchronization is not covered
  • None

Answer : Event CLI mode "show IP interface brief" synchronization

400-101 CCIE Routing and Switching Written Practice Exam Set 4

Which of the following steps prior to NAT activity usually occurs insidetooutside translation, but outsidetoinside Address Translation? (Choose the best answer.)


Options are :

  • None
  • Check the inbound access list, the heart rate limits and accounting
  • Policy routing and IP routing
  • Encryption and queuing
  • .checking outbound access lists and verify CBAC

Answer : Policy routing and IP routing

Which of the following statements is a flood of traffic VPLS network is that true? (Choose the best answer.)


Options are :

  • None
  • Just send flooded traffic over the network.
  • .Neither broadcast and multicast traffic propagate through the network.
  • Audiovisual multicast service is spread through the network.
  • Only multicast traffic is spread through the network.

Answer : Audiovisual multicast service is spread through the network.

Which of the following is not a VTP 3 version features? (Choose the best answer.)


Options are :

  • VLAN should be in the range of 1~1000.
  • It sends information in addition to the normal VLAN PVLAN.
  • It can use encrypted password for authentication.
  • None
  • . As the primary server.

Answer : VLAN should be in the range of 1~1000.

400-101 CCIE Routing and Switching Written Practice Exam Set 6

Which of the following first-hop routing protocol, up to four major arteriovenous fistula, to provide load balancing multiple WAN links? (Choose the best answer.)


Options are :

  • GLBP and HSRP
  • VRRP
  • GLBP
  • None
  • HSRP

Answer : GLBP

Which of the following types of authentication configuration command ISIS password? (Choose the best answer.)


Options are :

  • Domain Authentication
  • Verify District
  • None
  • User Interface Authentication
  • Verify router

Answer : User Interface Authentication

What is FF02 :: 5 destination device or device receives a packet? (Choose the best answer.)


Options are :

  • All nodes in the segment IPv6capable
  • .The single device is arranged to address FF02 :: 5
  • all OSPFv3 routers
  • . All IPv6capable router segment
  • All routers RIPv6

Answer : all OSPFv3 routers

400-101 CCIE Routing and Switching Written Practice Exam Set 4

Which of the following Cisco IOS XE consolidated package sub-package is always what's the difference? (Choose the best answer.)


Options are :

  • RPAccess
  • RPControl
  • RPIOS
  • RPBase
  • None

Answer : RPIOS

You manage Cisco routers PIM-SSM environment. Do you agree with the multicast source has multiple equal-cost paths to IP multi-hashing the basic commands of the router broadcast multipath grams. What will happen later? (Choose the best answer.)


Options are :

  • Based on the source, and a next hop address set in the router loadsplit.
  • Loadsplit router based on the source address and a group address.
  • Loadsplit based only on the source address of the router.
  • None
  • The router will send traffic to the highest PIM neighbor IP address.

Answer : Loadsplit router based on the source address and a group address.

Now to your IP multicastrouting command and SSM IP pim command in global configuration mode. Which of the following commands you can give each end of the SSM interface component? (Select three options.)


Options are :

  • ip igmp version 3
  • IP PIM passive
  • IP IGMP version 2
  • .IP PIM densemode
  • IP PIM sparsedensemode
  • IP PIM sparsemode

Answer : ip igmp version 3 IP PIM sparsedensemode IP PIM sparsemode

400-101 CCIE Routing and Switching Written Practice Exam Set 6

Comment / Suggestion Section
Point our Mistakes and Post Your Suggestions